Interested to Buy Any Domain ? << Click Here >> for more details...
Wat is da difference b/w neutral earthing and unearthed
system?
- 2 Answers
- 6090 Views
- I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
if it is balance or receiving end we don't want earth it
because source end already earthed.if it is source end
neutral should be earthed why because earth fault current
getting closed bath we can using earth fault protection if
it is high voltage system with out neutral earthing
resonance will be occur so we have do to the earthing at one
end
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why 9KV surge arrester having 7.65KV of MCOV?
how can i get an electrical c-certificate?
How to test REF relay testing for LV panel as per Kahramaa standard?
Why did lightening arrestor solid copper rod head is sharp on mobile tower top?
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
How one can check the MAIN of a house wiring ?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
State angle criterion.
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
Dear sir, I completed DECE In the year 1995.Now i am working in a private company from last 10 years as an Electrical supervisor.The company having a 1000 KVA transformer.Now i try to apply "C" Licence. I am eligible or not.If not eligible,pls give solution.
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
Why derating factor os applied on Cables?
