Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT HAPPEN WHEN CT SECONDARY OPEN DURING LOAD
- 16 Answers
- 31788 Views
- Neco, I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
I1N1=N2(I2+Ie)
primary ampere turn=secondary ampere turns
when secondary is open I2 is zero so primary ampere turn is
fully used for magnetizing the core so high voltage will be
induced in the secondary then core will be saturate.then
finally it will be blast. (Ie magnetizing current)
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
What is expention fastener (Fan)
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
why does a dc machine has high efficiency while working as a generator than as a motor ..
Why induction motor is widely used in industry
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
how to calculate current and voltage in a same circuit?
how to erect roof control panel?
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
What do you mean by lighting transformer?
