Answer Posted / maharajan
hysteresis loss =Bmaxpower 1.6 fv
eddy current loss= Bmaxsqrfsqrtsqrv
B-flux density
f-frequency
t-thickness of the core
v-voltage
in this loss all are constant so core loss is almost const
for all load
load loss=Isqrr
so it is depending upon the load and the internal resistance
for high efficiency core loss=copper loss
| Is This Answer Correct ? | 7 Yes | 5 No |
Post New Answer View All Answers
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
Name two types of electrical analogous for mechanical system.
how to check three phase motor torque value?
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
Explain cos(theta) and Sin(theta)
how could we calculate the no of outgoings from a 800 watt distribution board
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
neutral earth resistance testing is it possible for transformer while in load condition
State kirchoff current law?
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
what is the control circuit for operating the clean room air shower
where can the transformer having vector group Yny0 be used??
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
