Interested to Buy Any Domain ? << Click Here >> for more details...
can anybody give me current carrying capacity of cables
e.g size of cable in sq.mm & its current capacity
both alluminum & for copper
- 4 Answers
- 7591 Views
- I also Faced
- E-Mail Answers
Answer Posted / maharaja
1.5A/sqrmm for cu 1A persqrmm for aluminium
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
dear all i am kumara now current working in electrical designing of control and relay panel i want learn some substaion design then any book are available. pls mention name and authour
What is the name of transformers oil filteration equipment?
How to run a three phase motor into single phase........
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
What is the maximum operating temperature for a thermoplastic insulated cable?
i am completed my degree(B.E EEE) 2014 anychance to get electrical licence plz help me
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
tan delta equation test on alternators
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Write the force balance equation of m ideal mass element.
What is touch potential and step potential?
What is different between Difnit time and instatous over current relay
what is high and low cut off voltage of BB and DG at SPS????????
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
What do you understand by oldham's coupling ?
