Answer Posted / ravi roushan
through vfd.
Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
how to select proper cable for ct wiring so that drop within the limit.
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
why the perameters of secondary circuit are more important then that of the primary circuit of induction motor?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
What is transformation ratio what it describes?
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
how is the incoming cable size calculated for a given current rating of a panel??
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
ht side line to earth voltage
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?