Answer Posted / krishan chand tyagi
Transfomer overfluxing can be result of
1. Overvoltage
2. Low system frequency
A transformer is designed to operate at or below a maximum
magnetic flux density in the transformer core. Above this
design limit the eddy current in the core and nearby
conductive components cause overheating which within a very
short time may cause severe damage.The magnetice flux in
the core is proportional to the voltage applied to the
winding divided by thhe impedence of the winding.The flux
in the core increase with either increasing voltage or
decreasing frequency.During starrtup or stardown of
generator connected transformers, o following a
loadrejection, the transformer may exeperience an excessive
ratio of volts to hertz, that is, become overexcited.
| Is This Answer Correct ? | 95 Yes | 8 No |
Post New Answer View All Answers
pls,send the previous year written test questions.
previous year paper of ntpc bhel for degree in electrical enng
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
If not into production, how far did you follow the design and why did not you see it into production?
Draw the line diagram of diffretial relay connected to transformer?
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
Please nybody say, weather the result of Bharat Oman is declared or not? Probable date of declare???????
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
i want bhel placement paper for electrical if anybody having pl send to my id kavitha867@myway.com immediately
Pls mail me utility & Dg related question with answer
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
what is a reactive power? what is the relation with power factor?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
