Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raghu
imagine a dc current flowing in a resistive ckt.. it
produces (i^2)*R heat.. now imagine ac current in the same
ckt.. find out the power dissipated in the network by
integrating the sum of the squares of the instantaneous
values of the current under root.. and equate it to the
power dissipated by dc current.. the value obtained is rms
value..
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
how to differentiate a mpcb,mcb with a contactor? Explain their working operation
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
what are the installation procedure of high voltage power transformer,CT,CB&PT?
define reflection method?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
why Induction Generators are not "Black start" ? and apart from WTGs where this types of generator are generally used?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
Describe the control mechanism of missile launcher???
