Interested to Buy Any Domain ? << Click Here >> for more details...
where do we connect tap of tap changer, to H.V. side or
L.V.side? and why?
- 5 Answers
- 15038 Views
- Vedanta, I also Faced
- E-Mail Answers
Answer Posted / mohamed
Normaly its connected in the primary side of the
transformer its not a matter of HV or LV why we use the tap
changer? in case of variation in the input output also
varied ( increase or decrease)we need to maintain the
constant voltage at the output by varing the tape we can
get the constant voltage at the output the AVR also used
for the same function
| Is This Answer Correct ? | 1 Yes | 20 No |
Post New Answer View All Answers
What is the function of the generator exciter?
Define what is difference between fuse and breaker?
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
what are safety measures in /control in diesal engine/ explain them?
Define gain margin?
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
Details about Flux Compensated magnetic Amplifer starter for motors
How to Calculate KA Rating of Main LT Panel
previous year paper of ntpc bhel for degree in electrical enng
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
Define phase lag and phase lead?
How much weight an electrical engine can pull??
what is the transiant condition in alternator? and how it can be prevanted?
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
Difference between HRG and NGR. Are they both the same thing
