WHAT IS THE Differance b/w on/off & pid control valve?
- 10 Answers
- 35453 Views
- I also Faced
- E-Mail Answers
Answer Posted / bell
on/off will make full open or full closed position of the
valve,but pid will give percentage of valve open/close
according to the controller output.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
please tel me the calibration of pneumatic controler.
how do we commission inergen system?
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
There are many type of control cable like pair,core,tried, What are defination each one
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?
What is PDS and PDMS ?
you are on site,the plant trips,you are approached by operations,what do you do?
State some of balance principle’ advantages?
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
what is SIL 1 2 3
