Interested to Buy Any Domain ? << Click Here >> for more details...
what is derating factor in Cable ? how we minimise this?
- 18 Answers
- 118673 Views
- Bhel, College School Exams Tests, I also Faced
- E-Mail Answers
Answer Posted / yogesh zambre
Due to partial discharges in cable it can't be utilized to
it's rated capacity.
As current flowing to charge cable capacitance is extra
burden on that which will make it to carry less current for
load.
To reduce this good insulation material should be use.
| Is This Answer Correct ? | 5 Yes | 16 No |
Post New Answer View All Answers
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
who invented active elements? plz give me the complte details of active elements...
wheather the size of windings in motor and generator are the same
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
What is the different between digital phase converter and ordinary phase converter?
Give atleast 20 alternating current apparatus and devices.
can anybody send the rrb chennai &rrb bopal question papers of 2006&2007.My exam is on 12 oct 2008.Its urgent
why should the primary of transformer be connected in delta in a heat run test?
what is the need of starter in tube light and what type of starter is used in that?
What is purpose of reactor?.What is different between line and bus reactor?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
if we have 320KVA Genset kindly advice how much load we can put it.
