how we calculate the motor rating of pump for water
suction ?its any formula for that plz give thank u
Answer Posted / naresh
depends on the height of the buidling,depth of he water
coloumn for exmpl 300ft,400ft etc.....,horizontal path of
the water pipe,vertical path i.e height of the building,
after taking these one should calculate the no of satges for
ex 18,20,22 stages, 3ph r single phase power supply,voltage
230v/415v but the actual calculations no idea but these r
the constraints/the details required while selecting the
water pump motor
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How to work meggar?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
What is the approximate value of stacking factor?
How to calculate phase to phase difference ?
What is icu and ics in Acb and how many time icu or ics passes from breaker?
What are the limitations of Kirchoff's laws?
orifice sizing how done, checking & selection
pls someone send me sample question papers along with the key.thanks in advance
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
5.WHICH TYPE WELDING PROCESSES USES NON CONSUMABLE ELECTRODE.........
can any one suggest paper presentation topies for electrical engg?
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
Inductor and capacitor........power in one phase and ...... in it another phase.
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?