If single phase voltage level is 230V than why three phase
voltage level is not 660V ?, but it is only 440V.

Answer Posted / percy

3 phase doesnot means 230+230+230

in three phase three lines carry same voltage but displaced
in time by 120* that is we obtain V (L-L)=400kv

Is This Answer Correct ?    25 Yes 37 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.

1790


I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in

1545


What is meant by control system?

758


List some examples of renewable energy?

859


How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.

1273






1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?

2160


In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)

1394


What are the main faults of DC generators?

2467


1. What is the exact formula for one weber? for example,(one ampere = one coulomb electron of electrons crossing a point of conductor at one second. i.e, 1A=1Q/1sec)

1522


how to calculte capacitor range for single phase induction motors??pls tel

1724


WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM

1642


What is a slack bus?

728


at what base you will tell the direction of rotation of dc motors and generators?

749


for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?

1631


im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar

1517