Answer Posted / mukesh tyag

ATS is the Automatic Transfer Switch, The function of this
switch is that if the utility supply goes then the
connected equipment would be transfer automatic on
emergency source from utility source through this switch.

What is phase cross over frequency?

1056

---

HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM

1812

---

What is the difference between a Root Locus plot and a Bode plot?

1216

---

What is the function of capacitor in electrical circuits?

987

---

Difference between Earthing Truck & Earthing trolly for HT panel

4340

---

In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?

1642

---

Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.

1921

---

what is interfacing in computer studies?

1711

---

What is the purpose of using busbar mounting fuse?

1993

---

1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?

2235

---

Why 1/3 is used in symmetrical components?

1776

---

CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS

1815

---

if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?

1944

---

suri transmission

4696

---

Why did lightening arrestor solid copper rod head is sharp on mobile tower top?

1951

---