Interested to Buy Any Domain ? << Click Here >> for more details...
why we are using R,Y,B colours for 3 Phase ?
- 4 Answers
- 10611 Views
- ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / gopalakrishnan.e
the three color having very high traveling wave lengh so
easily identification for using this colors
| Is This Answer Correct ? | 14 Yes | 3 No |
Post New Answer View All Answers
What is a advantage of Self Reset Lockout ? On Fault breaker get trip & fault no longer exist then self reset lockout how inform us?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
Tell me in detail about c.t. And p.t. ?
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
how the characterstics of control valve being done
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
why we change the direction of winding in rotor ?how we make the north and south pole?
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
what is the meaning of WYE and DELTA in Electric meter?
