Interested to Buy Any Domain ? << Click Here >> for more details...
if earthing is used in place of neutral how the circuit
completd.
- 7 Answers
- 14908 Views
- Epitome, I also Faced
- E-Mail Answers
Answer Posted / jitender kotwal
the L.T side of the transformer star connection is there
and from the center of that netural point comes in picture
and it is assumed that at this point there is zero potential
but in unblance load this point cay carry the potential to
avoid this the netural is always connected to ground.
so if ground is used in place of netural the ckt will
complete as ground is at low (zero)potential
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
Can anyone tell the proper diagram of star delta starter????
which one is more efficient, torq, power & ecnomy with the same frame size AC motor / DC motor?
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
why does rotor rotets?
What are safety device in vcb and acb?
What is safety of Ht panel
how to calculate micom relay earth falt time and current sertting
Define bibo stability.
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
Difference between control junction box (cjb) and power junction box(pjb)?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
