Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / neeladree chakravorty
Yes we can .
In fact if we use higher frequency then according to the emf
relation of E=4.44fBAN,
we can see that for a given rated voltage, the Area of cross
section of the transformer core will reduce.
So the Volume of the transformer will be reduced and hence
it will be lighter and lower will be the material cost.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
how to calculate power consumption in slip ring motor at different step
How to Decide(calculate) Bush bar size for copper and aluminiam ?
wat is the first thing dat is needed, 2 lay a cable in some area??
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
what is the reactance,capacitance & impedence electrical armoured & unarmored Cables.
How to calculate Number of Earthing Pits....???
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
10 Mtr Hight of Lighting Arrestar how much area coverd??
What is the general system requirement of alternator?
what is (+) and (-) in generator field detector stand for?
How the capacitance og capacitor volatage transformer is decided?
Dear sir my name Ankit i m Diploma holder present working in Welspun Corp ltd Anjar as Asst.engg (salary 14400/month ctc) i Would like to change my company also i have selected in ford India pvt ltd Sanand as trainee Tech with salary 12000/month so please suggest me for changing my job hope for *ve response
