Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ankit trivedi
TO SELECT PROPER BUSBAR WE SHOULD KNOW THE LOAD CURRENT &
CROSS-SECTION AREA OF THE MATERIAL WHICH IS GOING TO BE
USED. IE CU OR AL.
I.e A CU. BUSBAR OF 25x6 Sq.mm. WILL CARRY THE CURRENT AS
BELOW
25X6 = 150 (cross section area)
150X1.6 =240A
THE BUS BAR OF 25X6mm. WILL CARRY 240A CURRENT, WHERE 1.6
IS GLOBLE SAFTY FACTOR.
| Is This Answer Correct ? | 28 Yes | 9 No |
Post New Answer View All Answers
Which Class insulation is prefered for the sandwich Busducts ? Why?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
Name of the relay of low lub oil presuure in DG sets
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
how to calculate the step resistance for slipring induction motor,how you deside the no of step for that?
What is the importance of earthing?
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
What is resistance reading of earth copper rod with grid and without grid?
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
How work of capacitor in dc supply...???
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
