Answer Posted / nagarjuna
THERE IS A DEVICE WHICH SENDS RAYS FROM ONE TERMINAL TO
OTHER TERMINAL(LIKE CAPACITOR)
LIKE
-------/ /-------
BETWEEN THESE A RAY WIL TRAVEL ,IF FIRE
WILL OCCUR MEAN ,SMOKE WILL FORM ,THAT SMOKE WILL BARRIER
THE LIGHT ,SO LIGHT WILL NOT ENTER FROM ONE TERMINAL TO
OTHER .SO THAT THE SENSOR SENSES THAT AND BLOW ALARM.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
Igfet is a
How equivalent impedance is calculated in thevenin theorem?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
What is open loop and control loop systems?
why do we carry out winding resistance test?
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
How to select the cable and voltage drop in circuit?
what is the differencce inn series and cascade connection??
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
where the lexical paramater will use in fron end?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
how to find the resistance and gap volatage of the diode??
What is meant by a stray loss of a induction motor??? What is the equation to find it
