WHAT IS THE REASON FOR THE GROUND PIN IS BIGGER IN SIZE
COMPARING TO OTHER PINS?
Answer Posted / m.srinivas manoj
when a fault occurs a large amount of current is drawn from
earth wire hence more thickness is required to avoid
insulation breakdown
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
How to decide whether A / B / C / D curve type MCB should be used?
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
Explain the functioning of diode?
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
1.Z transform always lies around ? a) origin b) pole c) zero d) z=1. Multiples Mcqs which is bother me can’t find answers on internet. Some help required with little explanation . Note: this is not homework or related to any test. Thanks
What is making & breaking current ???
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding
how to calculate fault level?
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
what will happen if frequency is below 50 hz?
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?