Interested to Buy Any Domain ? << Click Here >> for more details...
What happens if ac is applied to dc systems and vice versa?
- 5 Answers
- 8970 Views
- I also Faced
- E-Mail Answers
Answer Posted / senthilarun
we can give dc supply as ac by using an inveter and vice
versa was done by using rectifier.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
Why cables and busbar both needed in LT Panels?
difference between a diode and thyristor?
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
How to megger test 11 kV cable and the acceptance IR value
DEAR SIR,I GOT THE CALL LETTER FROM RRB, SECUNDERABD AS A JE-II SO PLEASE PROVIDE ME SOME MODEL QUESTION AND ANSWER PAPERS AND LAST YEAR QUESTION PAPERS
Ceiling Fan and Storage type water heater. Discuss
How to calculate the heat load for a electrical room
Why earthing is necessary for any equipment?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
What is mean by spike arrester(Voltage Operated)
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
Operation carried out in thermal power stations?
Difference between low impedance and high impedance Restricted Earth Fault
