Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jitendra patel
thanks ripul for this comments
ya,it is vent not went sorry for that
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
Calibration of controller (pneumatic)
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
What is shielding effect?
Name different types of bourdon tubes.
please send the drdo exam paper
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
How many types of sensor
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is diffrance between FF & SMART, explain with difination
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
Explain plc level and its type?
what is piezoelectric transducer?give an example in power plant n state its principle?
how to control pid
