A 11000/415V distribution transformer is fed 415V upon it's LT
side,Do I get 11000V upon it's Primary side ?
Answer Posted / t.somasundaram
in 11000/415v transformer,if we apply the 415 volt to the
secondry ,we can't get 11000 volt at the primary
side.because , some power losses will be occured .so the
voltage drop will be occured .so the transformer can't
produce the 11000 v at the primary .and also the 415 v is
not enough to produce voltage of 11000v.thus we can't get
the 11000v at primary for corresponding 415v secondry voltage
Is This Answer Correct ? | 8 Yes | 12 No |
Post New Answer View All Answers
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
how choose conductor&depending upon load
What is inverse definite minimum time lag relay? Where is it use?
why various test are performed on electrical panels & power cables before commissioning on site & what are these test???
how can maintaince the acb contactor moveing and fixing kit
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
what is the efficiency of thyristor
how to select the isolation tranformer for siemens 802dsl cnotroller
Why a Permanent Magnet Generator has higher frequency as compared to frequency of main alternator?
Anyone who can recommend an equivalent to Envirotemp FR3 of Cooper?
what happen if the supply is given to the stator of the 3phase induction motor with out assembling the rotor ?
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws: