if u have to give support in 1 km long bridge,where u will
give it & how many?
Answer Posted / rahul bahua
the bridge is of course a simply supported bridge..
what we can do is support the beam at the centre bcoz the maximum condition of failure will be at the centre..
it also applies symmetry..
the rest depends upon the load conditions..
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Heat a vessel with water inside and cool it under tap suddenly. Now when we try to open it...It does not open easily ...why?
how many types of jacks
hi friends pls send the bhel question papers is very urgent...
One unit of btu is how many joules?
how a cyclone steam separator works?
What is the difference between shear center flexural center of twist and elastic center?
dear friends pls explain me what is meant by positive seal in solenoid operated valve
Which tools are used in fitting shop?
Specific strength of materials is very high when they are in fibre size but lower when they are in bar form why ?
Why supercritical boilers use less amount of steel compared to non-supercritical boilers ?
What is a positive displacement pump?
tell me about a time when u had too many things to do and u were required opinion prioritized your talks
What is a radial-flow turbine?
on which basis safety valves are set with particular pressures?
How is propeller fitted in shaft?