Interested to Buy Any Domain ? << Click Here >> for more details...
How to use a insulation resistance tester on a three phase
electric motor?
- 2 Answers
- 6414 Views
- I also Faced
- E-Mail Answers
Answer Posted / pswin
The purpose of insulation resistance tester is to test the condition of insulation. On three phase motors, we need to do the insulation test between winding to windings and windings to ground. Before the testing, we need to take out the connections(star or delta). Choose 500 V scale on meter and proceed to test.Full scale will be 100 Mega Ohm. Minimum will be 0.5 Mega Ohm and if lower than this result, motor cannot be used.
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
1 hp is equal to how much watt?
What is the high series capacitance winding on high voltage power transformer ?
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
what do w do when the output of generator is fluctuating?
does any one know where we can purchase insulation oil for high voltage oil filled cables
what is the IS foe lightning arrester?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
what is the difference between torque induced and torque load?compare them with respect to dc motor?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
Draw the DOL starter and star delta starter drawing?
how to carried out DAR test in 11 KV Alternator ?
Batteries. What is the difference between Lead and Nickel batteries ?
