Interested to Buy Any Domain ? << Click Here >> for more details...
hi i'm an Instrumentation student,i have one doubt that we
can call-
> computer science as CS
> Information science as IS
> Electronics & communication as E & C
In the same way what is short term for Instrumentation....?
- 11 Answers
- 13395 Views
- I also Faced
- E-Mail Answers
Answer Posted / ivy
You can vry well E&I
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Q- What are the application in which PNP transistor is preferred over NPN ?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
What is eddy current? Describe the operating principle of proximity probe.
What is the basic difference between Modbus and CAN Open Protocols
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
give me all the details about the interview and which type of question being asked
this site is owned by an nonsense
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
use of split range ? where it is used ? in which control loop it is used ?
