Interested to Buy Any Domain ? << Click Here >> for more details...
why field winding is placed on rotor winding not on stator
winding in case of synchronous machine?
- 13 Answers
- 38481 Views
- HAL, TATA, I also Faced
- E-Mail Answers
Answer Posted / berti
In the case of a synchronous machine, large a.c currents
are to be taken from the armature windings, so the armature
is the stator. It is better to make the armature the
stator, if large currents are to be taken from it.
| Is This Answer Correct ? | 23 Yes | 4 No |
Post New Answer View All Answers
what are the main faults that occur in stabilizers? How they corrected and resolved ? Types of stabilizers ?
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
What type of fittings and electrical accessories can be install in radiation area ?
what is the reactive power what is the use of it in system
What are the types of piano switches?
What kind of maintenance is conducted for Transformer
How can we measure the residual voltage in dc machines?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
how can get electrical "c" licence.i am complited in DEEE.PASSING YEAR OF 1993.WORKING IN PVT COCERN LT LINE.PLEASE ADVISE ME .CELL NO 9994786021
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
