why companies are using First and third angle projection?
why not second and Fourth?
- 7 Answers
- 24187 Views
- CADD, I also Faced
- E-Mail Answers
Answer Posted / naveen
as 1st and 3rd angle projections r clearly viewed by the
person and easy to understand these views wher the front
view and rear view is been clearly viewed so in order to
avoid confussion and make it clear and wher as in 2nd and
4th angle the top view and front view is overlapped so they
r using 1st and 3rd angle projections are been used in
companies
| Is This Answer Correct ? | 37 Yes | 10 No |
Post New Answer View All Answers
Hi any one can help in preparing for BHEL ET exam in mechanical stream? I like to know the the question paper pattern fro the same. regards, Jose 9841327666 josevinoth@yahoo.com
What are the causes of damage of diesel engine exhaust Valve?
what is the velocity considering in lube oil drain line for lube of system for steam turbine?
hi,i am sekar.i am prepareing Assistant Motor Vehicle Inspector in TN.Transport ,if any one have previous year model pares or some questions,pls send me at gpsekar2007@gmail.com.
Machine tool guideways are usually hardening by ?
what happens at an equipment buyoff?
AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME
What s gland sealing steam?
What causes diesel engine trouble when using heavy oil?
state the microstructure of annealed and normalized
What is elasticity?
please send interview questions on foundry. my email id is m_vijaypanday@yahoo.co.in
What is g.i.?
please msg me tecnical question of hpcl
Are you ready to comply with the employment rules and regulations if your CV is considered for employment?
