What will the effect on a motor designed at 60 HZ, and
operated on 50 HZ ??
- 8 Answers
- 9570 Views
- I also Faced
- E-Mail Answers
Answer Posted / baskaran.r
when operating 50 hz the important change is voltage. we are
to make V/F as constant ie voltage /frequency equal there
fore to operate the motor in 50 hz we have to reduce the
voltage per v/f calculation. if operated with same voltage
the flex will saturate and motor will take high amps and
burn the speed will reduce to 1500 as stated.
| Is This Answer Correct ? | 8 Yes | 5 No |
Post New Answer View All Answers
what is spadar bar .why I use in DC generator.
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
What is the diffrence (Technical & Construction ) between CBCT & Normal CT?
Transformer how to maintaince a check b check c check d check
why the neutral point in connnection oscillates?
I have c license but I don't know eligibility of Max Kilo Volts under the electrical licensing board.
What is thresh hold value of current?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
Difference between megger test equipment and contact resistance meter test instruments?
What is a signal flow graph?
what is the transiant condition in alternator? and how it can be prevanted?
please send me latest & previous years question papers for IOCL Technical level questions
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
