Interested to Buy Any Domain ? << Click Here >> for more details...
What will the effect on a motor designed at 60 HZ, and
operated on 50 HZ ??
- 8 Answers
- 11787 Views
- I also Faced
- E-Mail Answers
Answer Posted / thowsif_emerson
Hi,
Normaly the motors will design for 4 Poles:-
W.K. That N=120f/P
If the motor is designed to operate on 60HZ its speed will
be 1800RPM,
If you operate the same motor on 50Hz Supply,then its speed
will reduced to 1500 RPM...
| Is This Answer Correct ? | 17 Yes | 5 No |
Post New Answer View All Answers
What is installed in PAC that is control the humidity
how many joint can done in HT line and what is life of the joint
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
What do you mean by turns ratio of instrument transformer?
What are the three major categories of error?
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
what will happen if ac and dc supplies given
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
where the lexical paramater will use in fron end?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
what is feeder bay?
How can we increase fuel-power ratio of any DG set?
