Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / thowsif_emerson
Electromagnetic induction relays operate on the principle
of induction motor and are widely used for protecting
relaying purpose involving a.c. quantities.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
how slip power recovery system work
What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.
Define newton's law of viscosity.
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
Brief working principle of stabilizer,application & safety precautions
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
What is the formulae of Megger value for a A.C.Motor
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
How many capacitors using in LT panel as per Govt rules?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
