Answer Posted / bertong_bayawak
a cascade controller means there is a 2 controller with its
primary controller's output, is the setpoint of the
secondary controller, where the desired controls takes
place.
Is This Answer Correct ? | 15 Yes | 0 No |
Post New Answer View All Answers
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
Why boiler chimney area oxyden sensor fixing?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
How to Calibrate Ultrasonic flow Transmitter in Field
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
Give 2 application of quartz crystal used for process parameter measurement.
What are different types of cable?
what is maxdna ?. explain about the software details.
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
What are the type of bonnets in the control valves?
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
What is modbus?
this site is owned by an nonsense