Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sindhu
in case any fault occurs in the transmission line, it is
used to isolate the healthy side from the faulty side i.e it
is used to protect the line from total damage.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What mean by MLTP
When lag/lead/lag-lead compensation is employed?
What are the advantage of free wheeling diode in a full wave rectifier?
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
size of condotory fron voltage level
what is the difference b/w ground & virtual ground?
Fantio of tranformer
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
How to check the LM324 Ic
advantages and disadvantages of inverse definite minimum time RELAY
Explain the construction of the conservator, operation and purpose, and draw the diagram of the conservator.
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
sugest any typical project ?
why single CT used in DOL starter power circuit?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
