Interested to Buy Any Domain ? << Click Here >> for more details...
what r the earthing required for commissioning of D.G set?
- 5 Answers
- 10781 Views
- I also Faced
- E-Mail Answers
Answer Posted / suthanprabhu
The neutral of the generator should be connected to earth
through a NGR.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
how could we know the size of cable by physical view?
how to know the diffrential relay setting of 06mva step- down (delta-star)transformer?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?
What is the formula to calculate the size of Aluminium and copper cable?
why ss stablity limit is more transient stablity limit?
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
sir plz send some previous year questions of jspl.
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
What is speed mode?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
