Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between inverter and ups & what is
the earth resistance for ups , if its high why so
- 3 Answers
- 7395 Views
- I also Faced
- E-Mail Answers
Answer Posted / abishekmittal
In inverter the switching takes some time whereas in UPS is
online i.e. the switching time is almost zero. So for all
critical applications like computer, we prefer UPS and for
normal usage we go for inverters.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is the classification of hydro projects based on installed capacity?
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
circuit diagram of trip circuit supervision relay
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
What is the difference between AC and DC injection methods for rotor earth fault protection
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
Explain the advantages and disadvantages of thermal power plant?
What is the lower limit of break-down voltage of converter transformer.
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
What is the settings of distance protection relay in 400 kv line
Define cut-off rate?
