What is the difference when selecting a cable between AC
and DC current?
- 13 Answers
- 50849 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / ramya
in ac the current supply are in alternating in nature
whereas in dc the current direct in nature.due to this ac
takes more current so it doesn't be widely used.in dc its
current consumptions are less,so its most probably used.
| Is This Answer Correct ? | 4 Yes | 45 No |
Post New Answer View All Answers
please explain to me how to calculate current,voltage,resistance with formula??
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
Define steady state error.
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
What happen to generator if i have unbalanced load?
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
How is the percentage impedence of a transformer fixed at design stage???
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
How to calculate Number of Earthing Pits....???
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
internally connection of photvoltic module
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
what is the maximim current drawn by 1 phase and three phase welding machine
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
