Interested to Buy Any Domain ? << Click Here >> for more details...
which grade of concrete is the strongest?
M20,M25,M30,M35 or M40?
- 41 Answers
- 145591 Views
- I also Faced
- E-Mail Answers
Answer Posted / sharad
M40 GRADE OF CONCRETE IS MORE STRONGER THAN OTHERS BECAUSE
CEMENT CONTENTS IS MORE IN CASE OF M40 CONCRETE.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
I Want To Know Quantity of Cement Conc. & Sand in Column of 9"x9"x10'
Requirement of cement, and steel 1:2:4 ratio concrete in 1128 Sqft area(Cement No of bags, steel in Kgs)
how to calculate the steel in 500yard
How do you determine specific gravity of cement?
Why was the empire state building made of steel?
residential projects,structural.
I have certain queries, please help to solve. a) length of pile bore is 4m.excavation quantity will be area * length where area will be pi/4 * dia*dia. Is this right? b) It is a single reamed pile of 300m dia and reamed dia is 750mm. can any body help me to calculate excavated quantity of this bulb(reamed section),, concrete quantity in bulb with showing the formulas to be used?
What the advantages and disadvantage of using 90mm and 100mm bricks for a wall of a house? Thanks for any input.
what is diversion?
what is conrete grade ,how are depent on concrete grad and size of concrete?
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
what is the soil bearing capacity for a 5 floor multistorey residential building and which type of soil ? what is plinth beam? in wall load calculation center to center column distance is considered or not/
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
what is hydrostatic paradox?
where tie beam is used? what is the pupose? what dimension of tie beam can provided and number and diameter of steel bars to be used between the columns of 1333mm and 1400.
