Interested to Buy Any Domain ? << Click Here >> for more details...
When is the maximum load on the lift/elevator,during
ascending or descending?Explain.
- 5 Answers
- 12677 Views
- MN Dastur, SPL, I also Faced
- E-Mail Answers
Answer Posted / parthiban . r
though theortically its true, if we think its going to be
descending the reason is the force of body falling down
will be comparitively more
for example: you could find it easily by following
throw a ball over a person in upstairs and then do with
person in downstairs from up
definetly the person at downstairs will get more pain than
upstairs
so a small amount of load will be more than that of
ascending.
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
What is weight of 1m3 of seawater?
What are the causes of emergency stop in a steam engine?
1.how do you purchase the sheetmetal,machined components for OEMS? 2.WHAT IS THE SYSTEM TO BE MAINTAINE FOR PURCHASE ACTIVITY? 3.HOW DO U DO THE PRICE NEGOTIATIONS & ITS PROCEDURES? 4.WHAT ARE THE PROBLEMS WILL FACE WHILE PURCHASING THE COMPONENTS& WHAT IS THE SOLUTION TO OVERCOME BY THAT ONE 5.WHAT IS THE NECESSARY NOTES TO MAINTAIN THE PO& RELEASING THE PO?
interviw tips for bhel supervisor trainee
What do you mean by A.CC.?
WHAT IS THE TOTAL HEAT RATE OF PLANT AND WHAT IS THE HEAT RATE OF BOILER?
What causes cylinder liner-wear down?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
how can we find the discharge pressure of the pump with the use of flow and NPSH?
what is cyclon seperator and water column?
whats the Formula to calculate temperature of steam at given pressure
Why thermal efficiency of i.c. Engines is more than that of gas turbine plant ?
Explain the difference between mill and mill-drill?
What type of boiler does not need a steam drum ?
what is the use of choper motor in pyrometer ?
