Answer Posted / dilip kumar

The earth pin in a 3-pin plug the longest and the thickest
because at the time of fault, the fault current must pass
through the earth connection to the ground, the fault
current produced is so many times greater than the normal
current.

Haw to check conductivity of budbar

1750

---

what is the k var ratting of 1250kva

1985

---

Refernce currents are to be generated using refernce cueernts how can this be done??

1951

---

What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?

2015

---

how to calculate micom relay earth falt time and current sertting

2403

---

How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).

2118

---

If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?

1842

---

What is safety of Ht panel

1604

---

y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..

1926

---

What is VCB? where it is installed at SP. What is SP?

2117

---

Why single phase induction motors are not self starting ?

1601

---

Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB

2686

---

salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers

2028

---

HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM

1812

---

what about SAP/MRP regarding manufacturing of electric motors and all drives?

1971

---