why the three phase transformer's star point does not
sparks or seperated? while we often see that two phases
touches each other it sparks and ocationaly conductor
breakes out.
- 4 Answers
- 7095 Views
- I also Faced
- E-Mail Answers
Answer Posted / kundan
at a time when all three phase are live,they have pik valyu
is +x,-x and 0. that mean if r is +50 that time b is -50
and y is 0, all calculation is =50-50+0=0. so total
voltage is 0 v.
if this is not real ans pls send me accual fact.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What are n circles?
What are the different losses In a de mac1une'! t.xplam
What is the automatic voltage regulator with servomotor?
What is the high series capacitance winding on high voltage power transformer ?
Dear friends I want to design busbar for1600 kva transformer(i.e2100 amps) what are all the factors to be considered before selectinga busbar what are all the standard sizes of busbars what is the formula for finding current of copper and aluminium busbar
why the protection turbo generators is most complex?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
What is touch potential and step potential?
how to calculate mf when meter and cTPT detail are given
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
