What is the Ideal Earth to Neutral Rating for Techonology
Equipment like Routers, Switched, PABX, Computers etc etc?
- 2 Answers
- 3573 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
It should be below 1volt
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
If VFD is On but no starting commond on it. so how many outpout voltages of VFD
why generator efficiency is more in swinburnes test?
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
How may I enrol or get admission to your program?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
what will happen if synchronous machine rotor fed from single phase ac supply
STATE USE OF ARC RUNNERS & SPLITTERS ?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
size of condotory fron voltage level
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
can i use ups power as a raw power for another ups
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
