What is harmonics. How does it get generated and means to
arrest harmonics
Answer Posted / umair qayyum
Deviation of an ac signal from pure sinoside causes the
harmonics to exist.They are generated both because of non
linear loads; and generators because of the nonuniform
srator windings and magnetic fields in practical case.
When a sonosidal voltage is applied to a linear load,a
proportional current is also drawn with it.But when it is
applied to a non linear load,it causes the current to vary
disproportionately with the voltage due to which
nonsinosidal waveforms are created containg
distortions,whereby 50/60 hertz frequency contains numerous
waveforms superimposed upon it which are the multiple
frequencies of the normal 50/60 hz sine wave.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
how to identify the cable quality and what is flame proof cable
importance of reactive power management
If VFD is On but no starting commond on it. so how many outpout voltages of VFD
hi plz send me reliance placement papers..i.e electrical technical papers that have been asked in reliance test.
3phase motor can be used as a Prime mover for alternator.
Which test will be more severe for VCB?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
errection check list for transformer maintenance
Can an inverter be used as a converter? How?
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
hello friends this is krunal here.. i have applied for he officer train in hpcl electrical stream.. any one who have applied before for electrical stream please help me out.. post ur reply to my mail id: krunal_airforce@yahoo.com.. any tips, old questions for paper or any help will do.. plz help me.. your faithfully, Krunal Darji
What is the cut-off rate?
What test must you do before powering up a circuit that you have been working on?