Interested to Buy Any Domain ? << Click Here >> for more details...
is there interlocking between duty and standby chilled
water pumps?
- 1 Answers
- 4051 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijay chander
yes, interlocking in automatic and manual is possible. it
can be interlocked in motor control center.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
What is the general power factor & min. power rating of TV,LCD type TV, CRt type TV, Scanner, printer?
xfhnchncv?
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
how test transfomer(3 phase75kva) by megger
How to calculate Voltage regulation of 22 KV Over head Line.
Draw torque - speed curve and load curve of induction motor? mark operating point ?
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
what is different between relay and plc?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
in star-delta tranformer,if the input of star connection is 400/7v 3 kva then what is the output of delta connection?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
What is the name of the winding to which supply is given?
