Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vishnudev jangaraj
transformer is not electromechanical machine.It works on
the principle of mutual inductance.current flowing in the
primary coil produces magnetic field which inturn induces
emf in the secondary coil.Based on the number of turns we
can classify the transformer as step-up or step-down.This
is the reason why transformer is not rotating
| Is This Answer Correct ? | 1 Yes | 18 No |
Post New Answer View All Answers
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
State the points to be considered for selecting a particular type wiring.
what is the relative size of single and three phase?
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
how can maintain the power factor and why and this is how do work tell us
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
How to calculate the heat load for a electrical room
c++ write a program to use a fuction call "max"which accepts an intger arrey of size5.as an arrument and return the larger and smallest of the arrey to main without changing. the original changing of the original position of the element of the arrey.
Explain Energy and Power signals?
What is the principal of motor?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
why core is useful for a transformer ?and also in its operation ?
