Answer Posted / sr

The factors involved in cable sizing are:
1. Voltage grade
2. Various Derating factors depending on cable laying
(direct in ground), ambient temperature considered, group
factors (all these data are available in cable catalogue)
3. Length of cable laying for calculating voltage drop.
Voltage drop shall generally be within a max. of 3%.

What is the general system requirement of alternator?

1831

---

If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?

1432

---

how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?

2415

---

i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.

1917

---

We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.

1846

---

how braking & making capacity of circuit breaker is calculated?

1989

---

how we can calcultae the short circuit level for bus bar

2224

---

How does PLC work for sychronising of Two or more DG sets?

2058

---

how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.

1907

---

WITCH CARDS IN USE IN FIRE CONTROL PANEL.

1900

---

while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends

2843

---

Why Ac Systems Are Preferred Over Dc Systems?

1288

---

Can anyone tell the proper diagram of star delta starter????

1917

---

what is the relation between size of the anteena and wavelenghth of radiated wave

2163

---

What are PLC leader logic program method

1751

---