Interested to Buy Any Domain ? << Click Here >> for more details...
What is mean CT Saturation? How to calculate?
- 13 Answers
- 113617 Views
- NCC, I also Faced
- E-Mail Answers
Answer Posted / ajit
Now if a ct of the ratio of 5 A / 10 mA and i want 1 v out
put sec voltage, above that it should saturate. Presently
voltage increase up to 3.5 volt.
shall we change the core or no. of turns?
| Is This Answer Correct ? | 13 Yes | 17 No |
Post New Answer View All Answers
why do we not use equivalent voltage source in negative sequence equivalent ckt.
what is The difference between national electrical code and I.S.Code (electrical) and what is the value of NEC in electrical engineering field
how can i find cable size from current rating?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
What is the drawback of class b amplifier?
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
What is gain margin?
how to extend relay operating timing in 24V dc relay card (without using Timer )
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
EXPLAIN THE TRANSFORMER MAINTENANCE?
what is meant by IGBT how they differ from tyristor ?
what is resver in electrical enginnering with answer
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
