Questions :-
HR-
Q.1 about yourself & family background ?
Q.2 Why u choose Power sector as ur carrier starting not any
other sector ??
Q. 3 What think abt NTPC ?
Techincal Questions:-
Q.1 about Vocational Training……What u did , see the main
equipments….etc
Q.2 Why a transformer Noise during its running condition ?
Q.3 about transformer oil material & Test name for the
measurement of its dielectric strength & wht will u do if
its dielectric strength goes low ? ……..some discussion type ?
Q.4 What is relation between transmission lines &
Communication lines ?
Q.5 Which Machine u will prefer to use at a place where
flammable gases are coming out & why ?
Q.6 how fault in an electric system is detected & hw
protection of equipments is done ?
Q.7 Why we didn’t feel electric shock in an electric train ??
Q.8 Anything u want to ask from us ??
- 44 Answers
- 39202 Views
- Akona Engineering, Bhel, BSES, Cranex, DRDO, JCB, NTPC, I also Faced
- E-Mail Answers
Answer Posted / k.ramarajan
PLZ SEND U'R ANSWER TO dinesh_rajan1986@yahoo.co.in
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
i need list of swg(standard wire guage) or area of conductor v/s current carrying capacity of conductor copper & alluminium...
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
WHAT IS THE DIFFERENCE BETWEEN AN ACB & mccb 7 WHAT IS THE CRITERIA WHEN TO USE WHICH OF THE TWO
Give some differences between open loop and closed loop?
i want some interview related questions with their answers which can help for attend the interviews...
11000volt DG set carnt kaise banvay
If increased the frequency up to 1000 then what changes shows in voltage?
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
What is inverse definite minimum time lag relay? Where is it use?
How REF protects transformer alone? explain with diagram.
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
what percent do you derate your copper wire when you change from copper buss to copper wire
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
Draw transformer phasor diagram.(full load,no load)
