Interested to Buy Any Domain ? << Click Here >> for more details...
What are the rating wise protections required for
Generators from 600KVA to 2000KVA
- 3 Answers
- 5085 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashutosh
On the Basis Of Rating
there are following types of protection is required
1) Overvoltage Protection
2) Undervoltage Protection
3) Over Current Protection
4) Under Current Protection
5) Overheat Protection
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
What is Phase margin?
When lag/lead/lag-lead compensation is employed?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
what is circuit recombiner and how it is different from circuit breaker
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
What is a copper loss or i2r loss pc?
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
Which is the largest hydropower station in the world?
draw a circuit diagram connecting transformer OLTC- RTCC- VCB-Marshalling Box otherwise Explain in words
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
Different types of relay fault which phase sequence??
What is maximum power transfer theorem?
