WHAT IS THE REASON FOR THE GROUND PIN IS BIGGER IN SIZE
COMPARING TO OTHER PINS?
Answer Posted / abhisek
coz...if dia is increased..then resistence drop....so its
compatable high current going in ground...
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
Mr. mohh sahid m not satisfied for ur answer to the que weather the size of transformer increases or decreases withchange in fr for more detail go to the answer given by me
What is capacitance?
whether fibre optic cable in high voltage earth conductor is used for protection circuits
state types of reflectors in illumination engg. ???????
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
What is notching in dc machine?
3 phase induction motor connection star or delta while using ac drive motor is .75 to 5.5 kw
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
Difference between a pilot wire and a normal conductor?
What is stacking factor? What is its approximate value?
what are the applications of transistors with low dc gain, high dc gain and medium dc gain( beta)?
How many points does a Circuit can have?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,