why after termination of HT cable armoured earth connected
one end, why not connect other end.pls tell me correct
answer.
- 3 Answers
- 9710 Views
- I also Faced
- E-Mail Answers
Answer Posted / nazeer
it is becoz that if u connect both the ends 2 earth there
would be a loop created so that eddy cyrrents may flow n
may case insulation failure or over heating 2 the cable.
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
Can anyone please give me the parameters , formula needed to calculate the circuit breakers for building services.Thanks
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
What does the letter CTNM in negative phase sequence relay means?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
What is the difference between PLC and Embeded system
What do you understand by oldham's coupling ?
WHAT IS DIFFERENCE BETWEEN CAPACITOR AND CAPACITANCE?
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
CALCULATE THE TOTAL VOLTAGE DROP AND SELECT THE CABLE SIZE IN MM-SQARE FOR A PANEL-262KW AT 110 METER FROM THE SOURCE SUPPLY , SUPPLY VOLTAGE 240/415
how can i get the formula to find out the cable size if i know the load of main fuse protection.
What is I to C?
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
EXPLIAN THE IMPORTANCE OF POLY PHASE CIRCUIT.
