In generation,transmission and distribution voltage
frequency is either 50HZ or 60 HZ;why are only these
frequencies?
Answer Posted / binay agrawal
if we give approx 1500rpm to stator, only that case good
induction is covered, & the winding is of genetrally 4 pole.
so according to N=120f/P,
Frequency should be around 50-60HZ.
Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
What is the difference between earthing,ground&nutral?
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
What do you mean by transformation ratio of instrument transformer?
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
What are the different types of hydro schemes?
What is critical disruptive voltage?
Define non-touching loop.
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What is difference between Harmonic and Non harmonic Capacitor Bank?
Why syn. Generators are used for the production of electricity?
Why does the adjacent zone of protection overlap?
Advantages of using generator circuit breaker (GCB) scheme in a power station ?
How to measure size of cable on a given load
Explain Even and Odd signals?